Df command in Linux not updating actual diskspace, wrong data

Df command in Linux not updating actual diskspace, wrong data

Mattias Geniar, Friday, November 26, 2010 - last modified: Wednesday, March 29, 2017

This is an annoying problem on a lot of Linux distributions, and it can have several causes.

Caused by open file descriptors

If you delete files from the filesystem, the command "df -h" might not show the deleted space as being available. This is because the deleted files could still be held open by (defunct) processes, where the file descriptor handles still point to those files. As a result, the df command assumes the files are still there, and doesn't clear the space.

Here are some ways you can track which processes still refer to the deleted files.

# lsof | grep 'deleted'
# ls -ld /proc/* | grep '(deleted)'

The solution is to either stop the process (kill <PID>, or the more agressive kill -9 <PID>), or if that doesn't work to restart the server in general.

Reserved space for journaling

Alternativaly, if you're using a journaling filesystem (like EXT3), keep in mind that df will also count the space used for this journal log in the output.

Default block reservation for super-user

Also keep in mind that there will, by default, be a 5% block reservation for the super-user per blockdevice (in short: for every seperate partition on a hard disk in your system). You can check the amount of reserved space, by running the tune2fs -l command.

# tune2fs -l /dev/sda2 | grep -i reserved
Reserved block count:     208242
Reserved GDT blocks:      1016
Reserved blocks uid:      0 (user root)
Reserved blocks gid:      0 (group root)

As it's described in the mkfs.ext3 manual, for the -m parameter.

-m: Specify the percentage of the filesystem blocks reserved for the super-user.  This avoids fragmentation, and allows root-owned daemons, such as syslogd(8), to continue to function  correctly  after  non-privileged processes are prevented from writing to the filesystem.  The default percentage is 5%.
0 (0)
Article Rating (No Votes)
Rate this article
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Full Name
Email Address
Security Code Security Code
Related Articles RSS Feed
RHEL: Scan and configure new SAN (fibre channel) LUNs
Viewed 7298 times since Sun, May 27, 2018
logrotate Understanding logrotate utility
Viewed 1468 times since Sun, Jan 12, 2020
Linux How to reset a root password on Fedora
Viewed 1764 times since Sun, Dec 6, 2020
HP-UX - Stunnel Configuration
Viewed 2059 times since Fri, Sep 28, 2018
Netcat shell zabezpieczony hasłem
Viewed 1788 times since Thu, May 24, 2018
Using etckeeper with git
Viewed 6119 times since Sun, Jun 3, 2018
red hat 7 tmpfiles service
Viewed 1409 times since Thu, Oct 11, 2018
Sample logrotate configuration and troubleshooting part 2
Viewed 9040 times since Fri, Nov 30, 2018
VMWare tools free
Viewed 8037 times since Mon, Jul 16, 2018
systemd Auto-restart a crashed service in systemd
Viewed 2296 times since Fri, Jan 17, 2020